Sam Wormley wrote:
Perspicacious wrote:
There was another word in the 16th century that stopped
discussion and paralyzed thinking. The word was "heretic."

You really do need to recognize your mindless rage and
honestly confront your medieval mind. If you can attain
that, then learn math next and recognize your obsession
with deceit. Try to reform. Aim to be honest. Becoming
marginally civilized will improve your sour disposition.

Time is homogeneous. It possesses an indistinguishable
sameness everywhere, point by point, across all inertial
frames of reference. There are no fatal flaws in
http://www.everythingimportant.org/r...ty/special.pdf


Time is malleable--being affected by gravitation and
velocity.


Time is the only thing that is NOT malleable.

A measurement consists of two parts,
some standard unit,
and the number of these standard units
that make up the measurement.

ALL physics properties are referenced to
whatever is selected as the standard time reference.

The standard time reference provides the ticks
that quantize time. Times are time periods which are auto-correlations
associated with some single point.

The standard time reference provides the ticks
that quantize time intervals.

Time intervals are the most fundamental measurement of spaces.
Einstein rulers are nasty temperature sensitive, pressure sensitive,
bending sensitive, contamination sensitive, acceleration sensitive
beasts.

Spaces are time intervals
which are cross-correlations associated with two points,
one being called the cause or initial point,
and the other being called the effect or end point.

Time intervals are commonly multiplied by a constant "C"
and called spaces. As can be seen, "C" can be ANY value you like, as
all it does is differentiate between time periods and time
intervals.The selection of "C" is a political process,
and commonly selected to express time intervals
in terms of some kings body parts.

Masses are aggregates of time periods (Times)
and time intervals (Spaces).

mass(object A) * G / C^3 = time interval(mass(object B))^3 / time
period(Common to both objects)^2

As can be seen G/C^3 is a universal time per mass constant.

In addition to possessing the mechanical properties
of mass, energy, momentum, etc. aggregates of time periods and time
intervals also possess the electrical properties of capacitance and
inductance.

"G", the "conductivity" of space ( G(space) = 1 / Z(space)
is the constant used to express aggregates of time periods and time
intervals in the electrical domain just as "C" is used to express time
intervals in the space domain, and "C" and "G" are used to express
time/space aggregates in the mass domain.

The following charts demonstrate these relationships:

The chart below shows expresses the properties in the time/space
domain.
--------------------------------------------------------------------------
l' t[p]' acceleration
vel' One vel
g' t[p] distance
t[p]^2

Note that the acceleration of the Earth is called "g",
and that t[p] (Time periods) are functions of distance and "g".

time period^2 = distance / acceleration

The chart below shows expresses the properties in time domain.
--------------------------------------------------------------------------
t[i]' t[p]' g / C
r' One r
C / g t[p] t[i]

t[p] = time period
t[i] = time interval
r = time interval / time period

The chart below shows expresses the properties in the electrical
domain.
--------------------------------------------------------------------------
C' t[p]' L'
Z One Z^-1
L t[p] C

C = capacitance
L = Inductance
Z = Impedance

Note that t[p] (Time periods) are functions of inductance and
capacitance.

time period^2 = L * C

Be advised that as time periods are commonly expressed
in both cycles and in radians, it is necessary to use the
constant (2 * pi) to get the numerical result in the desired units.

It is my personal opinion that ALL properties should be expressed in
integer units based on cycles, and that the physical units that have
been contaminated with radians should be redefined.

If all properties are referenced to cycle counts,
there will only be an unambiguous plus or minus one count error,
whereas the use of radians introduces real numbers,
with the resultant ambiguity.

To sum up,
note that times are the count of ticks of the standard clock
and that time periods are auto-correlations associated with a single
point, and that time intervals are cross-correlations associated with
two points, and that the mass domain and electrical domain properties
are composites of time periods and time intervals.

In other words,
it is wasteful, confusing, and non-viable
to use models and equations promoted by
race, religion and nationality,
and to twist all of the succeeding properties
that are based on simple, quantum, integer counts
of a standard clock.

General Relativity is a Tower of Babel
that twists time domain, mass domain and electrical domain properties.

It generates more heat than light,
and wastes time, money and minds
on such pursuits as time travel, worm holes, black holes,
bending, warping and dragging space, etc.

Basically GR was an effort to extend stress analysis maths and theories
to the larger universe, but as the universe is more like a dynamic gas,
than it is like a solid, bound body, it is not viable to use these
techniques to model the larger universe.

A mind is a terrible thing to waste.

--
Tom Potter
http://home.earthlink.net/~tdp
http://photos.yahoo.com/tdp1001
http://tom-potter.blogspot.com